blade cutter Manufacturers

In summer, many factories run chillers 24 hours a day, which is very efficient. But in winter, many factories in some areas do not need chillers for cooling. When the chiller is shut down, the chiller must be maintained.

Industrial chillers are used to cool molding molds in plastic machinery, which can greatly improve the surface finish of plastic products, reduce surface marks and internal stress of plastic products, keep products from shrinking and deformation, facilitate demoulding of plastic products, and accelerate product shaping.

The chiller can be divided into two types in the application of the extruder, one is to cool the extrusion die, and this one can use a standard chiller. There is another type of water tank for cooling the extruder line groove. This model needs to use a shell-and-tube chiller (the evaporator is a shell-and-tube closed type). Jiusheng will teach you to match the corresponding power of the extruder with a 200KG output. Chiller. The extrusion capacity is 200KG/H. The chilled water flow rate is 5.0m³/H. If it is an air-cooled chiller, choose 10HP cooling capacity, and the model is JSFL-10. If it is a water-cooled chiller, choose 10HP cooling capacity. The model is JSSL-10. The water-cooled chiller needs to be connected to a pipeline water pump and a water tower. The air-cooled chiller can be used independently and is easy to install.

This article introduces the maintenance of water-cooled chillers.

Installation environment: It is best to install it at a distance of more than 50 cm from the wall. The operating environment is preferably below 45°C. The air-cooled chiller needs to have a good heat dissipation environment while cooling.

Air-cooled Chiller uses the method of air cooling, which reduces the equipment required for traditional cooling, effectively avoids the scaling of condensers and the blockage of water pipes caused by poor water quality, and is conducive to saving water resources.