shredder Manufacturers

The user is an old user who repurchased again. In the first half of last year, the customer ordered a 50HP air-cooled chiller. After using it for about a year, he felt that the effect of the chiller was good, and he made good use of our company's chiller. experience. So at the end of this year, we continued to place new orders for 2 chillers.

The clamping force of the injection molding machine is 400T-640T, and the molding capacity is 40KG/H-64kg/H. If it is an air-cooled chiller, choose 8HP cooling capacity, and the model is XYFL-08. If it is a water-cooled chiller, choose 8HP cooling capacity.

Frequently asked questions about the use of industrial water coolers: When operating an industrial water cooler, you should try to avoid turning it on and off repeatedly. When the temperature of the industrial water cooler exceeds the set temperature, the compressor will stop running on its own. This is a normal situation.

The reason why the industrial chiller does not cool may be due to insufficient refrigerant, dirt in the condenser, improper position of the slide valve, leakage of cold air, fouling of the evaporator, and so on. The high-pressure alarm failure may be caused by frequent start and stop of the chiller, dirty pipeline, low or unopened cooling water flow, too much cold coal, poor heat dissipation of the condenser, and excessive opening of the expansion valve.

The chiller can be divided into two types in the application of the extruder, one is to cool the extrusion die, and this one can use a standard chiller. There is another type of water tank for cooling the extruder line groove. This model needs to use a shell-and-tube chiller (the evaporator is a shell-and-tube closed type). Jiusheng will teach you to match the corresponding power of the extruder with a 400KG output. Chiller. The extrusion capacity is 400KG/H. The chilled water flow rate is 10m³/H. If it is an air-cooled chiller, choose 20HP cooling capacity, and the model is JSFL-20. If it is a water-cooled chiller, choose 20HP cooling capacity. The model is JSSL-20. The water-cooled chiller needs to be connected to a pipeline water pump and a water tower. The air-cooled chiller can be used independently and is easy to install.

The chiller can be divided into two types in the application of the extruder, one is to cool the extrusion die, and this one can use a standard chiller. There is another type of water tank for cooling the extruder line groove. This model needs to use a shell-and-tube chiller (the evaporator is a shell-and-tube closed type). Jiusheng will teach you that the 150KG output extruder matches the corresponding power.