dehumidifier drying Manufacturers

The water resource consumption characteristics of the open type water-cooled chiller are directly related to its thermodynamic cycle mode.

The chiller can be divided into two types in the application of the extruder, one is to cool the extrusion die, and this one can use a standard chiller. There is another type of water tank for cooling the extruder line groove. This model needs to use a shell-and-tube chiller (the evaporator is a shell-and-tube closed type). Jiusheng will teach you to match the corresponding power of the extruder with a 400KG output. Chiller. The extrusion capacity is 400KG/H. The chilled water flow rate is 10m³/H. If it is an air-cooled chiller, choose 20HP cooling capacity, and the model is JSFL-20. If it is a water-cooled chiller, choose 20HP cooling capacity. The model is JSSL-20. The water-cooled chiller needs to be connected to a pipeline water pump and a water tower. The air-cooled chiller can be used independently and is easy to install.

Air-cooled Shell And Tube Chiller, is an efficient and widely used refrigeration equipment.

The clamping force of the injection molding machine is 240T-400T, and the molding capacity is 24KG-40kg/H. If it is an air-cooled chiller, choose 5HP cooling capacity, and the model is XYFL-05. If it is a water-cooled chiller, choose 5HP cooling capacity. The model is XYSL-05. The water-cooled chiller needs to be connected to a pipeline water pump and a water tower. The air-cooled chiller can be used independently and is easy to install.

The reason why the industrial chiller does not cool may be due to insufficient refrigerant, dirt in the condenser, improper position of the slide valve, leakage of cold air, fouling of the evaporator, and so on. The high-pressure alarm failure may be caused by frequent start and stop of the chiller, dirty pipeline, low or unopened cooling water flow, too much cold coal, poor heat dissipation of the condenser, and excessive opening of the expansion valve.