Home > News

Industry News

Reasons and solutions for industrial chillers not cooling

The reason why the industrial chiller does not cool may be due to insufficient refrigerant, dirt in the condenser, improper position of the slide valve, leakage of cold air, fouling of the evaporator, and so on. The high-pressure alarm failure may be caused by frequent start and stop of the chille......

Is it better to choose air-cooled or water-cooled chiller?

With the increasing application of industrial chillers, such as: plastic industry, petrochemical industry, electronics industry, vacuum coating, etc. will use industrial chillers. Its applicable places have increased, and the specifications and models of manufacturers and chillers are also increasin......

Injection molding machine selection matching mold chiller calculation formula

The cooling capacity of the selected chiller directly affects the normal use of production equipment and operating efficiency. If the selected cooling capacity is too small, it will not be able to achieve the final cooling effect, which will not only reduce the production efficiency of the enterpris......

How to quickly deal with the low-temperature chiller compression molding machine card?

It is widely used in some industries such as industry, and the compressor jam of low-temperature chiller is a serious problem, which needs to be dealt with in time to avoid further damage to the equipment. However, when some enterprises are operating low-temperature chillers, the system condenser ha......

How to choose a chiller for extruder

Concrete mixing plant is a common construction equipment. Concrete mixing plant needs to use a lot of concrete in the production process. During the production process of concrete, water needs to be continuously added to adjust its viscosity and fluidity. Therefore, cooling water is needed to contro......

How much is the price of electroplating oxidation chiller? How to choose?

The structure of the electroplating oxidation chiller can be selected according to the structure of the customer's electroplating tank.For example, if the indirect cooling method is used to lay heat exchange tubes inside the electroplating tank, and chilled water flows through the heat exchange tube......

<...10 11 12 13 14...29 >

We use cookies to offer you a better browsing experience, analyze site traffic and personalize content. By using this site, you agree to our use of cookies. Privacy Policy

Reject Accept